Cisco CTS-3010 Administration Manual page 125

Chapter 5 Troubleshooting the CTS 1000
Aligning the Camera
To set the camera alignment using the Cisco TelePresence System Administration interface, follow these
steps:
Step 1 Log in to the Cisco TelePresence System Administration window.
Step 2 Choose Troubleshooting > Hardware Setup.
Click the Cameras radio button.
Step 3
Click Start. The display enters loopback mode. In loopback mode, the display shows images from the
Step 4
camera.
A "flipped" or mirror image for the selected screen(s) is displayed automatically. This simulates the
Note
image that attendees will see to help you make sure that all three cameras are vertically aligned.
Step 5 Click Show Camera Target.
Make sure that the camera target is still secured to the table.
Note
Step 6 Loosen the thumbscrew on the camera and twist the zoom ring on the lens until the curved lines on the
left and right are just touching the left and right borders of the screen. Tighten the thumbscrew when the
adjustment is complete.
Step 7 If required, align the camera so that the target is centered in the picture by using the screw-and-spring
mechanisms on the camera mounting plate that is shown in
You can adjust the pan (the panoramic sweep on the x-axis) and pitch (the fore-to-aft tilt on the y-axis)
angles, and pivot. These angles are adjusted using the three sets of screws shown in
angles the screws adjust are as follows:
•
•
•
These adjustment capabilities are moderate and might not correct for a display frame that is not level.
Note
OL-13676-05
Middle two screws—Allows you to set the yaw angle of the camera. See
section on page 5-12 for more information.
Top screw —Sets the pan angle. See
more information.
Bottom screw—Sets the pitch angle. See
for more information.
Figure 5-3.
"Adjusting the Pan of the Camera" section on page 5-12
"Adjusting the Tilt of the Camera" section on page 5-13
Cisco TelePresence System Release 1.6 Administration Guide
Managing Hardware Setup
Figure 5-3. The
"Setting the Camera Yaw"
for
5-9