Table of Contents
Advertisement
Chapter 7
Troubleshooting the CTS 1300
Figure 7-78
Horizontal Bars and Focusing Targets
Large
target
Small
target
Red and green
horizontal bars
When the bars are roughly the same length, the camera is focused.
e.
Step 7
Click Done to complete the procedure.
Focusing the Left Camera
To focus the left camera, complete the steps in the following procedure.
If you logged out of the GUI, you must re-select the correct table type after you log in; otherwise, you
Note
could configure your system for the incorrect table type. To select the correct table type, complete
in the
In the Cisco TelePresence administrative GUI, click the Right radio button.
Step 1
Click the Setup button that is located below the center screen icon.
Step 2
Click Show Focus Targets.
Step 3
Position the small camera target by completing the following steps:
Step 4
a.
b.
Step 5
Position the large target by completing the following steps:
a.
b.
c.
Note
d.
OL-13676-04
Without moving the focus ring, tighten its thumbscrew.
"Positioning the Table and Starting the Calibration Procedure" section on page
Place the target on the table approximately one foot (30 cm) from the edge where the participants sit.
Position the target so that the top two patterns on the target are enclosed in the green box.
Remove the large focus target from the easel.
Rotate the target 90 degrees.
Have another person hold the target upright.
If another person is not available, clamp the top of the target into the clamp at the top of the easel.
Place the top of the easel five feet (1.5 meters) behind the top of the small target.
Cisco TelePresence System Release 1.6 Administration Guide
Managing Hardware Setup
Red
rectangle
Green
rectangle
Step 5
7-51.
7-85
Advertisement
Table of Contents
Troubleshooting
