Table of Contents
Advertisement
Chapter 7
Troubleshooting the CTS 1300
Adjust the camera mounting plate to center the red plus sign (+) on the display inside the black plus sign
Step 5
(+) on the target.
Figure 7-18
Use the top two screws for left and right adjustment.
•
•
The lower screw for up and down adjustment.
The screws in the middle for adjustments on the horizontal plane (rotational).
•
Figure 7-18
Side to side
adjust screw
Step 6
Adjust the camera zoom by completing the following steps:
a.
Loosen the thumbscrew for the zoom ring on the camera lens.
Note
b.
Adjust the camera zoom so that the black curved line on the right of the target touches the right edge
of the display screen, as shown in
c.
After you adjust the zoom, make any required adjustments to the focus with the focus ring.
OL-13676-04
shows the screws that you use to adjust the camera. Use a 2.5 mm Allen wrench.
Camera Adjustment Screws
Left
adjust
screw
Up/down
adjust
screw
The zoom ring is labeled "W-T."
Up/down
adjust
screw
Figure
7-19.
Cisco TelePresence System Release 1.6 Administration Guide
Managing Hardware Setup
Right
adjust
screw
Side to side
adjust screw
7-23
Advertisement
Table of Contents
Troubleshooting
