Table of Contents
Advertisement
Chapter 7
Troubleshooting the CTS 1300
Step 7
Click Done to complete the right camera focusing procedure.
Focusing the Right Camera
To focus the right camera, follow these steps.
If you logged out of the GUI, you must re-select the correct table type after you log in; otherwise, you
Note
could configure your system for the incorrect table type. To select the correct table type, complete
in the
In the Cisco TelePresence Administration window, click the Right radio button.
Step 1
Click the Setup button that is located below the center screen icon.
Step 2
Click Show Focus Targets.
Step 3
Position the small camera target by completing the following steps:
Step 4
a.
Place the target on the table one foot from the edge where the participants sit.
b.
Position the target so that the topmost patterns on the target are enclosed in the green box.
Step 5
Position the large target by completing the following steps:
a.
Remove the large focus target from the easel.
b.
Rotate the target 90 degrees.
c.
Have another person hold the target upright.
Note
Place the top of the easel five feet behind the top of the small target.
d.
Position the target so that the topmost patterns are enclosed in the red box.
e.
Adjust the camera focus by completing the following steps:
Step 6
Loosen the thumbscrew for the lens focus ring.
a.
Twist the focus ring clockwise until the red and green horizontal bars on the bottom of the screen
b.
are reduced to very short lengths on the left.
Note
Twist the focus ring counter-clockwise until the red and green bars extend all the way to the right.
c.
Continue to twist the focus ring until the red and green bars are approximately the same length. See
d.
Figure 7-44
length, the camera is focused.
The red and green bars do not have to be exactly the same length, but get them as close as you can.
Note
OL-13676-04
"Positioning the Table and Starting the Calibration Procedure" section on page
If another person is not available, clamp the top of the target into the clamp at the top of the easel.
Figure 7-43
shows a mirror image of the horizontal bars.
to view the approximate horizontal bar alignment. When the bars are roughly the same
Cisco TelePresence System Release 1.6 Administration Guide
Managing Hardware Setup
Step 5
7-51.
7-47
Advertisement
Table of Contents
Troubleshooting
