Table of Contents
Advertisement
Chapter 7
Troubleshooting the CTS 1300
Figure 7-1
Figure 7-1
Note
CTS initial setup is also performed using the Hardware Setup fields. For information on how to configure
CTS for the first time, see the
Replacement Unit
Configuring the CTS 1300 Table
Before you can set up the cameras in a Cisco TelePresence System 1300 (CTS 1300) conference room,
the Cisco TelePresence System (CTS) software needs to know the size and shape of the table in the room.
On the CTS 1300 administration page, a drop-down menu is provided that allows you to specify the
shape of the table in the room and where participants will be seated.
Note
The CTS 1300 is designed to be used in any type of multipurpose room. However, to ensure that you
have the best conferencing experience, Cisco recommends that you optimize your room by using the
guidelines and recommendations in
in the
Specifying the Table Size and Shape
Figure 7-2
OL-13676-04
shows the Cisco TelePresence System Hardware Setup troubleshooting window.
Troubleshooting Window
Cisco TelePresence System 1300 Assembly, Use & Care, and Field
Guide.
Cisco TelePresence System 1300 Assembly, First-Time Setup, and Field-Replaceable Unit
shows the CTS 1300 table configuration menu.
Cisco TelePresence System 1300 Room Recommendations
Cisco TelePresence System Release 1.6 Administration Guide
Managing Hardware Setup
chapter
Guide.
7-3
Advertisement
Table of Contents
Troubleshooting
