Table of Contents
Advertisement
Chapter 7
Troubleshooting the CTS 1300
Figure 7-30
Click Apply.
e.
Click Stop to stop the test.
f.
Choose Troubleshooting > Hardware Setup.
Step 7
Click the Cameras radio button.
Step 8
Step 9
Click Start to start the camera test.
Step 10
Click Show Camera Target.
Step 11
Automatically adjust the cameras by completing the following steps.
a.
In the Auto Brightness field, perform one of the following actions:
•
•
b.
In the Auto Color Balance field, perform one of the following actions:
•
•
c.
In the 50 Hz Flicker Reduction field, click the Disable radio button.
OL-13676-04
Table Configuration Menu
If the room uses outside lighting, or has any other conditions that could cause variable room
lighting, click the Enable radio button.
If your room lighting is not variable, leave the default value.
If the room uses outside lighting, or has any other conditions that could cause variable room
lighting, click the Enable radio button.
If your room lighting is not variable, leave the default value.
Cisco TelePresence System Release 1.6 Administration Guide
Managing Hardware Setup
7-35
Advertisement
Table of Contents
Troubleshooting
