Cisco CTS-3010 Administration Manual page 137

Chapter 5 Troubleshooting the CTS 1000
Table 5-6 Supported Presentation Devices
Presentation Device
Projector
Document Camera
The projector is set up successfully when the test pattern is displayed on the projection surface in the
meeting room while running the test.
Tip When troubleshooting presentation devices, start with the projector test pattern to see if the projector is
set up correctly and then proceed through VGA and document camera input tests as necessary.
Use the information in the following sections to test presentation devices:
•
•
•
•
•
•
OL-13676-05
Included in Cisco TelePresence System
—
—
Checking the Test Pattern, page 5-22
Checking the VGA, page 5-22
Checking the Document Camera, page 5-23
Resetting the Projector, page 5-23
Troubleshooting Presentation Devices, page 5-23
Related Information, page 5-25
Optional in Cisco TelePresence System
CTS 1000
•
• CTS 1000
Cisco TelePresence System Release 1.6 Administration Guide
Managing Hardware Setup
5-21