Optional) Installing An In-Room Fingerprint And Card Reader With A Keypad - Huawei FusionModule2000 Installation Manual

FusionModule2000 Smart Modular Data Center
Installation Guide
1.
2.
----End
16.5 (Optional) Installing an In-Room Fingerprint and
Card Reader with a Keypad
Context



Procedure
Step 1 Remove the screws (set aside) from the fingerprint and card reader with a keypad and take off
the baseplate, as shown by (1) in
Figure 16-19 Installing a fingerprint and card reader with a keypad
Step 2 Mark the mounting holes using a marker, and drill holes using a hammer drill.
Issue 02 (2018-03-31)
If the magnet cannot attract the door properly after power-on, place a magnetized metal
part near the magnet to check whether the magnet provides a proper magnetic force.
If the magnetic lock and the magnet do not work properly, check and troubleshoot the
circuit.
The BOM number of a fingerprint and card reader with a keypad is 02070174.
It is recommended that the device be installed outside a room 1.4-1.6 m above the floor.
Do not install the product in a place with heavy dust or exposed to sunlight.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
16 (Optional) Installing In-Room Access Control
Figure 16-19.
Devices and Cameras
257