Huawei FusionModule2000 Installation Manual page 77

FusionModule2000 Smart Modular Data Center
Installation Guide
Step 2 Open the cabinet door, turn the lock head to reveal the rear of the lock head, and turn the key
to the initial position.
Step 3 Slowly turn the wheel of the code lock, observe from the calibration hole at the rear of the
lock head, and align the calibration hole with the semicircular notch of the wheel.



----End
Changing a password
Step 1 Enter the old password and turn the knob to unlock.
Step 2 Turn the knob 15 degrees counterclockwise, and turn the wheels to set a new password.
Figure 6-12 Changing a password
Step 3 Turn the knob 15 degrees clockwise.
----End
Issue 02 (2018-03-31)
There is a semicircular notch and a square notch on the wheel of the code lock. Align the
calibration hole with the semicircular notch.
After the semicircular notches of the three password wheels are aligned with the
calibration hole, the displayed password is the password set for the last time.
After you retrieve the password, you are advised to change it.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 Installing the Network Cabinet, IT Cabinet, and Battery
Cabinet
68