Xconfiguration Audio Output Line [1] Delay Mode; Cameras Configuration; Xconfiguration Cameras Camera [1] Backlight Defaultmode; Xconfiguration Cameras Camera [1] Brightness Mode - Cisco TelePresence SX20 Codec Reference Manual

Cisco TelePresence SX20 Codec

Introduction

xConfiguration Audio Output Line [1] Delay Mode

You may add extra delay to an audio line output with the Audio Output Line [n] Delay DelayMs
setting. The extra delay added is either a fixed number of milliseconds, or a number of millisec-
onds relative to the detected delay on the HDMI output (typically introduced by the connected
TV).
Requires user role: ADMIN, INTEGRATOR
Default value: RelativeToHDMI
USAGE:
xConfiguration Audio Output Line
where
: Unique ID that identifies the audio line output. Range: 1..6
n
: Fixed/RelativeToHDMI
Mode
Fixed: Any extra delay (DelayMs) added to the output, will be a fixed number of
millisecond.
RelativeToHDMI: Any extra delay (DelayMs) added to the output, will be relative to the
detected delay on the HDMI output. The actual delay is HDMI-delay + DelayMs. The
Audio Output Connectors Line [n] DelayMs status reports the actual delay.
SX20 Codec API Reference Guide CE9.1, JUNE 2017.
D15316.07
About the API xConfiguration xConfiguration
n Delay Mode: Mode
xCommand

Cameras configuration

xConfiguration Cameras Camera [1] Backlight DefaultMode

This configuration turns backlight compensation on or off. Backlight compensation is useful
when there is much light behind the persons in the room. Without compensation the persons
will easily appear very dark to the far end.
Requires user role: ADMIN, INTEGRATOR
Default value: Off
USAGE:
xConfiguration Cameras Camera
where
: Unique ID that identifies the camera. Range: 1..1
n
: Off/On
DefaultMode
Off: Turn off the camera backlight compensation.
On: Turn on the camera backlight compensation.

xConfiguration Cameras Camera [1] Brightness Mode

Define the camera brightness mode.
Requires user role: ADMIN, INTEGRATOR
Default value: Auto
USAGE:
xConfiguration Cameras Camera
where
: Unique ID that identifies the camera. Range: 1..1
n
: Auto/Manual
Mode
Auto: The camera brightness is automatically set by the system.
Manual: Enable manual control of the camera brightness. The brightness level is set
using the Cameras Camera [n] Brightness DefaultLevel setting.
37
API Reference Guide
xStatus Appendices
n Backlight DefaultMode: DefaultMode
n Brightness Mode: Mode
Copyright © 2017 Cisco Systems, Inc. All rights reserved.