For Tripod Joint Type Drive Shaft - Suzuki Ignis Service Manual

1
10) Remove drive shaft assembly.
CAUTION:
To prevent breakage of boots, be careful not to bring
them into contact with other parts, when removing drive
shaft assembly.
11) For vehicle with center shaft
Remove center bearing support bolts (3) and remove center
bearing support (2) with center shaft (1) from differential side
gear.
3
2
DISASSEMBLY

For Tripod Joint Type Drive Shaft

1) Remove differential side boot band, then take out tripod joint
housing (1).
2) Remove grease from shaft and take off snap ring (1) by
using special tool, then pull out spider (2) from shaft.
Special tool
(A) : 09900-06107
CAUTION:
To prevent needle bearing of joint from being degreased,
do not wash it if it is to be reused.
FRONT DRIVE SHAFT 4A-5