Table of Contents
Advertisement
3C-10 STEERING WHEEL AND COLUMN
1
3) Install contact coil and combination switch assembly (3) to
steering column.
NOTE:
New contact coil and combination switch assembly is
supplied with contact coil set and held at its center posi-
tion with a lock pin (1) and seal (2). Remove this lock pin
after installing contact coil and combination switch
assembly to steering column.
4) Install steering column upper cover (2) and lower cover (3),
and then tighten steering column cover screws (1).
CAUTION:
When installing lower cover (3) and upper cover (2), be
careful so that contact coil and combination switch lead
wire is not caught between covers.
5) Install steering column hole cover (1).
6) Install steering wheel to steering column. Refer to "STEER-
ING WHEEL".
STEERING COLUMN ASSEMBLY
CAUTION:
Once the steering column is removed from the vehicle,
the column is extremely susceptible to damage.
• Dropping the column assembly on its end could col-
lapse the steering shaft or loosen the plastic shear
pins which maintain column length.
• Leaning on the column assembly could cause it to
bend or deform.
Any of the above damage could impair the column's col-
lapsible design.
NOTE:
When servicing steering column or any column-mounted
component, remove steering wheel. But when removing
steering column simply to gain access to instrument
panel components, leave steering wheel installed on
steering column.
Advertisement
Table of Contents
