Table of Contents
Advertisement
3) Install bevel pinion shaft with new pinion shaft spacer (1) to
transfer output retainer.
4) Press-fit pinion shaft bearing (rear side) (2) by using special
tool (and press).
Special tool
(A) : 09913-75810
CAUTION:
Press-fit bearing to such an extent that spacer is not
compressed.
5) Drive in oil seal (1) by using special tools and apply grease
to oil seal lip.
Special tool
(A) : 09913-75810
(B) : 09951-16090
"A" : Grease 99000-25010
Transfer bevel pinion shaft oil seal installing depth
"a" : 27.0 – 27.5 mm (1.063 – 1.083 in.)
2. Bevel pinion shaft
6) Install flange (2) and tighten flange nut gradually so as rota-
tion torque of bevel pinion shaft to be in specified value.
NOTE:
• If rotation torque of bevel pinion shaft exceeds specifi-
cation given below, replace pinion shaft spacer and
tighten flange nut.
• Before taking measurement of rotation torque, rotate
pinion shaft over ten rounds in advance.
Special tool
(A) : 09930-40113
Rotation torque for bevel pinion shaft
(b) : 0.5 – 1.3 N·m (0.05 – 0.13 kg-m, 0.30 – 0.90 lb-ft)
1. Power wrench
3. Torque wrench
7) Caulk flange nut.
TRANSFER 7D-15
Advertisement
Table of Contents
