Table of Contents
Advertisement
3) Remove suspension control arm bolt (1).
4) Remove suspension control arm (2).
F: Forward
DISASSEMBLY
1) Remove bushing.
Place suspension control arm onto flat surface side of spe-
cial tool and push out bushing with special tool and oil
hydraulic press as shown.
Special tool
(A) : 09943-77910
NOTE:
If it is impossible to remove bushing as shown above
procedure, cut portion (1) of bushing (2) as shown in fig-
ure.
ASSEMBLY
1) Press-fit bushing by using special tool and press.
Special tool
(A) : 09943-77910
CAUTION:
Be sure to use new bushing.
NOTE:
• Before installing bushing, apply soap water on its cir-
cumference to facilitate installation.
• When installed, bush should be equal on the right and
left of arm as shown.
FRONT SUSPENSION 3D-17
Advertisement
Table of Contents
