Table of Contents
Advertisement
(B)
(A)
2
1
7) Install cup (1) and washer (2) such a direction as shown.
NOTE:
• Primary cup is the same as secondary cup.
• Primary cup is the largest compared with that of cap
and sleeve.
8) Remove cap cup (1) from cap with caring not to cause any
damage to inside of cap (2).
9) Install cap cup and O-rings (3) to cap such a direction as
shown.
10) Install cap and tighten it to specified torque, then confirm the
length "A".
Tightening torque
Cap (a) : 14 N·m (1.4 kg-m, 10.5 lb-ft)
Cap installation position
"A" : Less than 26 mm (1.02 in.)
INSPECTION AFTER ASSEMBLY
1) Install radiator cap test with special tool to master cylinder
port (1).
NOTE:
For without ABS vehicle, install special tool (B) to oppo-
site side port (2).
Special tool
(A) : 09952-46010
(B) : 09952-26020
2) Apply air and confirm that pressure is not applied.
BRAKES 5-37
Advertisement
Table of Contents
