Unit Repair Overhaul; Engine Assembly - Suzuki Ignis Service Manual

6A1-68 ENGINE MECHANICAL (M13 ENGINE)

UNIT REPAIR OVERHAUL

ENGINE ASSEMBLY

REMOVAL
1) Relieve fuel pressure according to procedure described in
Section 6.
2) Disconnect negative and positive cables at battery.
3) Remove engine hood after disconnecting windshield washer
hose.
4) Remove right and left side engine under covers.
5) Remove A/C compressor belt (if equipped).
6) Remove water pump belt.
7) Drain engine oil, transmission oil or A/T fluid (for A/T vehicle)
and transfer oil (for 4WD vehicle).
8) Drain coolant.
WARNING:
To help avoid danger of being burned, do not remove
drain plug (1) and radiator cap while engine and radiator
are still hot. Scalding fluid and steam can be blown out
under pressure if plug and cap are taken off too soon.
9) Remove air cleaner assembly, resonator and hoses referring
to "AIR CLEANER ASSEMBLY AND RESONATOR".
10) With hose connected, detach A/C compressor from its
bracket (if equipped).
NOTE:
Suspend removed A/C compressor at a place where no
damage will be caused during removal and installation of
engine assembly.