Table of Contents
Advertisement
(b)
1, (a)
1, (a)
INSTALLATION
1) Install LSPV assembly with spring to vehicle body.
2) Torque each bolt and nut (1) to specification as indicated
respectively in figure.
Special tool
(A) : 09950-78230 (10 x 11 mm)
Tightening torque
LSPV adjust nut (a) : 25 N·m (2.5 kg-m, 18.0 lb-ft)
Brake pipe flare nuts (b) : 16 N·m (1.6 kg-m, 11.5 lb-ft)
3) Fill reservoir with specified fluid and bleed air from brake
system.
4) After bleeding air, check that LSPV is installed properly
referring to following "INSPECTION & ADJUSTMENT".
INSPECTION AND ADJUSTMENT
1) Confirm the following before inspection and adjustment.
• Fuel tank is filled with fuel fully.
• Vehicle is equipped with spare tire, tools, jack and jack han-
dle.
• Vehicle is free from any other load.
• Vehicle is placed on level floor.
2) Push up LSPV lever with finger till it stops and measure
length of coil spring ("a" in figure).
3) Spring length "a" should be as specified.
Spring length "a"
2WD : 144 mm (5.67 in.)
4WD : 148 mm (5.83 in.)
4) If it isn't, adjust it to specification by changing spring position
as shown in figure. After adjustment, tighten nut (1) to speci-
fied torque.
Tightening torque
LSPV adjust nut (a) : 25 N·m (2.5 kg-m, 18.0 lb-ft)
NOTE:
Check to make sure that LSPV body and brake pipe joints
are free from fluid leakage. Replace defective parts, if
any.
5) Confirm fluid pressure referring to "Fluid Pressure Test".
BRAKES 5-49
Advertisement
Table of Contents
