On-Vehicle Service; Precautions; Abs Hydraulic Unit Operation Check (Using Suzuki Scan Tool); Abs Hydraulic Unit Operation Check (Not Using Suzuki Scan Tool) - Suzuki Ignis Service Manual

ON-VEHICLE SERVICE

PRECAUTIONS

When connector is connected to ABS hydraulic unit/control mod-
ule assembly, do not disconnect connectors of sensors with igni-
tion switch ON. Then DTC will be set in ABS control module.
ABS HYDRAULIC UNIT OPERATION CHECK
(USING SUZUKI SCAN TOOL)
1) Connect SUZUKI scan tool to data link connector (DLC) (1)
Special tool
(A) : 09931-76011 (SUZUKI scan tool)
(B) : Mass storage cartridge
(C) : 09931-76030 (16/14 pin DLC cable)
2) Turn ignition switch to ON position and check actuator oper-
1
(C)
(A)
(B)
ABS HYDRAULIC UNIT OPERATION CHECK
(NOT USING SUZUKI SCAN TOOL)
1) Check that basic brake system other than ABS is in good
2) Check that battery voltage is 11 V or higher.
3) With ABS warning lamp, check that no abnormality is
4) Lift up vehicle.
5) Set transmission to neutral and release parking brake.
6) Turn each wheel gradually by hand to check if brake drag-
with ignition switch OFF.
ation using "HYDRAULIC CONTROL TEST" under "miscel-
laneous test" ("MISC. TEST") mode of SUZUKI scan tool.
condition.
detected in ABS. Refer to "DIAGNOSTIC TROUBLE CODE
(DTC) CHECK" in this section.
ging occurs. If it does, correct.
ANTILOCK BRAKE SYSTEM (ABS) 5E-31