Table of Contents
Advertisement
5-38 BRAKES
2, (b)
3, (a)
1
3) Set master cylinder (1) on vise (3) and adjust "A" to be the
4) Apply air with radiator cap tester, and confirm that 50 kPa
5) Perform same steps 1)-4) for port (2).
INSTALLATION
1) Install new master cylinder gasket to booster.
2) Install master cylinder to booster and tighten master cylinder
3) Connect brake pipe to master cylinder and tighten flare nut
4) Connect fluid level switch connector (1) of reservoir.
5) Fill reservoir with specified brake fluid up to its MAX mark.
6) After completing above work, bleed air and check brake
3, (a)
BRAKE BOOSTER
REMOVAL
1) Remove master cylinder assembly from booster. Refer to
2) Disconnect vacuum hose from booster.
following.
Cap adjustment position
"A" : 50 mm (1.97 in.)
pressure is applied.
fixing nuts (3) to specified torque.
Tightening torque
Master cylinder fixing nuts (a) : 13 N·m (1.3 kg-m, 9.5 Ib-ft)
(2) to specified torque.
Tightening torque
Brake pipe flare nuts (b) : 16 N·m (1.6 kg-m, 11.5 Ib-ft)
pedal for play.
CAUTION:
Never disassemble brake booster. Disassembly will spoil
its original function. If faulty condition is found, replace it
with new one.
"MASTER CYLINDER".
Advertisement
Table of Contents
