Washer Tank And Washer Pump - Suzuki Ignis Service Manual

8-24 BODY ELECTRICAL SYSTEM
Automatic Stop Operation
1) Connect battery positive terminal to terminal "L" and its neg-
ative terminal to motor bracket (wiper ground) and let the
motor turn.
2) Disconnect terminal "L" from battery positive terminal, and
let the motor stop.
3) Connect terminal "L" and "S" with a jumper wire, and connect
terminal "B" to battery positive terminal. Observe the motor
turns once again then stops at a specified position.
L H
4) Repeat Step 1) to 3) several times and check that the motor
S
B
stops at the specified position every time.
If check result is not satisfied, replace.

WASHER TANK AND WASHER PUMP

REMOVAL
1) Disconnect negative cable at battery.
2) Remove front fender lining (RH).
3) Remove washer tank attaching nuts and inlet pipe (4).
4) Disconnect pump lead wire coupler(s) and hoses.
5) Remove washer tank (1).
6) Remove front washer pump (2) and rear washer pump (3) (if
equipped) from washer tank (1).
INSTALLATION
Reverse removal procedure for installation.
INSPECTION
1) Connect battery (+) and (-) terminals to pump (+) and (-) ter-
minals respectively.
2) Check motor operation for both front and rear (if equipped)
washer pump.