Front Wiper Motor - Suzuki Ignis Service Manual

[A]
B3 AS
W H L
HU
HE M B2 RF HL
[B]
WASHER LINKED CIRCUIT INSPECTION
1) Make sure that front wiper switch is at "OFF" position.
2) Connect battery positive terminal to terminal "B3" and its
3) Connect voltmeter positive lead to terminal "H" and its nega-
4) When front washer switch is ON (pushed to forward), check
[A] : LH steering vehicle
[B] : RH steering vehicle
AS L H B3 W
HU
HL RF B2 M HE

FRONT WIPER MOTOR

INSPECTION
Motor Operation (Low Speed)
1) Connect battery positive terminal to terminal "L" and its neg-
2) Check motor revolution speed as specification.
Front wiper motor specification (at low speed)
: 44 - 52 r/min (rpm)
Motor Operation (High Speed)
1) Connect battery positive terminal to "H" and its negative ter-
L H
2) Check motor revolution speed as specification.
S
B
Front wiper motor specification (at high speed)
: 64 - 78 r/min (rpm)
negative terminal to terminal "HE".
tive lead to terminal "HE".
that voltage changes as shown in figure.
Washer switch
ON
OFF
Voltage
between
"H" and "HE"
10-14V
0V
Approx. 0.3 sec.
ative terminal to motor bracket (wiper ground).
minal to motor bracket (wiper ground).
BODY ELECTRICAL SYSTEM 8-23
Approx. 1.6-3.6 sec.