Table of Contents
Advertisement
10) Remove bevel pinion (1) with rear bearing, and spacer from
carrier.
11) Remove bevel pinion rear bearing (2) by using bearing puller
(3) and press.
12) Drive out bevel pinion bearing outer race (1) by using metal-
lic stick (2).
INSPECTION
• Check differential input hub for wear or damage.
• Check bearings for wear or discoloration.
• Check differential carrier for cracks.
• Check drive bevel pinion and bevel gear for wear or cracks.
• Check side gears, pinion gears and pinion shaft for wear or
damage.
• Check side gear spline for wear or damage.
ADJUSTMENT AND ASSEMBLY
Judging from faulty conditions noted before disassembly and
what is found through visual check of bearing and gear tooth etc.
after disassembly, prepare replacing parts and proceed to reas-
sembly according to procedures as described below.
CAUTION:
• Bevel gear and pinion must be replaced as a set when
either replacement becomes necessary.
• When replacing taper roller bearing, replace as inner
race & outer race assembly.
REAR DIFFERENTIAL 7F-11
Advertisement
Table of Contents
