Table of Contents
Advertisement
2) Install trailing arms (1) (right & left) to rear axle in proper
direction as shown in figure.
Tighten rear trailing arm nuts (2) temporarily at this step.
A : Vehicle outside
B : Vehicle center side
3) Install coil springs (1) (right & left) on spring seat (2) of rear
axle and raise rear axle.
NOTE:
Upper and lower diameters of coil spring are different.
Bring larger diameter end at bottom and set its open end
in place on spring seat.
A : Upper side
4) Install shock absorber (1) lower sides (right & left) to rear
axle.
Tighten shock absorber lower bolts (2) temporarily at this
step.
5) Remove floor jack from rear axle.
6) Clean mating surfaces (right and left) of rear axle with brake
back plate and apply water tight sealant as shown in figure.
"A" : Sealant 99000-31090
7) Install brake back plates (1) (right and left) and tighten back
plate bolts (2) to specified torque.
Tightening torque
Brake back plate bolts (a) : 23 N·m (2.3 kg-m, 17.0 lb-ft)
REAR SUSPENSION 3E-17
Advertisement
Table of Contents
