Table of Contents
Advertisement
6) Install snap ring (1).
NOTE:
Make sure that the ends of the snap ring do not come to
the opening of the front clutch No.1 drum.
7) Place special tool (A) on soft jawed vise (1) and install 2 oil
seal rings on special tool.
Special tool
(A) : 09926-26050
(B) : Rear cover seal ring 24742-78F10 SUZUKI GENUINE
PARTS
NOTE:
• Rear cover seal set has two seal rings in a set.
• Do not use the seal rings removed from rear cover. It is
not necessary to remove seal rings from special tool
once installed.
8) Place direct clutch assembly (1) on special tool (A).
9) Set dial gauge (4) on the top of clutch flange (2) and mea-
sure clearance by blowing compressed air (4 kg/cm
as shown in figure.
If the clearance is out of specification, replace clutch discs,
plates and flange.
Direct clutch disc clearance
: 0.50 – 1.04 mm (0.0197 – 0.0409 in.)
3. Air gun
AUTOMATIC TRANSMISSION (4 A/T) 7B-103
2
, 57 psi)
Advertisement
Table of Contents
