Table of Contents
Advertisement
INSPECTION
Clutch and Brake Discs
Dry and inspect them for pitting, burn flaking, wear, glazing,
cracking, charring and chips or metal particles imbedded in lining.
If discs show any of the above conditions, replacement is
required.
NOTE:
• If disc lining is exfoliated or discolored, replace all
discs.
• Before assembling new discs, soak them in A/T fluid
for at least two hours.
Clutch and Brake Plates and Flanges
Dry plates and check for discoloration. If plate surface is smooth
and even color smear is indicated, the plate should be reused. If
severe heat spot discoloration or surface scuffing is indicated, the
plate must be replaced.
1st & 2nd Brake Piston Return Spring Subassembly
Measure height of 1st & 2nd brake piston return spring.
Height of 1st & 2nd brake piston return spring
20.81 mm (0.819 in.)
NOTE:
• Do not apply excessive force when measuring spring
height.
• Perform measurement at several points.
Evidence of extreme heat or burning in the area of clutch may
have caused springs to take a heat set and would require their
replacement.
AUTOMATIC TRANSMISSION (4 A/T) 7B-87
Advertisement
Table of Contents
