Suzuki Ignis Service Manual page 876

52) Install O-rings to each accumulator piston and apply grease
or ATF to them.
Grease 99000-25030
NOTE:
C1 and B0 accumulator pistons are the same.
53) Install C1 and B0 accumulator pistons (1 and 6), springs (2,
3 and 7) and spacers (4).
Hold them with snap rings (5).
NOTE:
• Make sure that snap rings are fitted to the groove of
each cylinder.
• Make sure that O-rings are not twisted or caught when
installing.
54) Install C0, B1, C2 accumulator springs (9, 12, 13, 15 and
16), spacer (11) and pistons (8, 10 and 14) as shown in fig-
ure.
NOTE:
Make sure that O-rings are not twisted or caught when
installing.
1. C1 accumulator piston
2. C1 accumulator outer spring
(with Yellow paint)
3. C1 accumulator inner spring
(with Yellow paint)
4. Spacer
5. Snap ring
6. B0 accumulator piston
7. B0 accumulator spring
(with Purple paint)
8. C0 accumulator piston
55) Install wire-to-solenoid assembly (1).
NOTE:
Apply grease to O-ring of wire-to-solenoid assembly.
Tightening torque
Wire - to - solenoid assembly bolt
(a) : 8 N·m (0.8 kg-m, 6.0 lb-ft)
Grease 99000-25030
AUTOMATIC TRANSMISSION (4 A/T) 7B-131
9. C0 accumulator spring
(with Pink paint)
10. B1 accumulator piston
11. B1 accumulator spacer
12. B1 accumulator inner spring
(with Orange paint)
13. B1 accumulator outer spring
(with Orange paint)
14. C2 accumulator piston
15. C2 accumulator inner spring
(with Light Blue paint)
16. C2 accumulator outer spring
(with Light Blue paint)