3E-10 REAR SUSPENSION
9) Lower hoist and vehicle in non-loaded condition, tighten
absorber lower bolt (1) and lateral rod right side nut (2) to
specified torque.
Tightening torque
Rear shock absorber lower bolt
(a) : 58 N·m (5.8 kg-m, 42.0 lb-ft)
Lateral rod right side nut
(b) : 65 N·m (6.5 kg-m, 47.0 lb-ft)
10) If equipped with LSPV, check and adjust LSPV spring refer-
ring to "LSPV INSPECTION AND ADJUSTMENT" and per-
form "FLUID PRESSURE TEST" in Section 5.
BUMP STOPPER
REMOVAL
1) Hoist vehicle and remove rear wheel.
2) Remove bump stopper (1) using flat tip rod or the like (2).
INSTALLATION
1) Install bumper stopper.
NOTE:
Before installing bushing, apply soap water on it.
2) Install wheel (1) and tighten wheel nuts (2) to specified
torque.
Tightening torque
Wheel nuts (a) : 85 N·m (8.5 kg-m, 61.5 lb-ft)