Table of Contents
Advertisement
5) Remove water pump assembly (1).
INSPECTION
CAUTION:
Do not disassemble water pump.
If any repair is required on pump, replace it as assembly.
• Rotate water pump by hand to check for smooth operation.
If pump does not rotate smoothly or makes abnormal noise,
replace it.
INSTALLATION
1) Apply sealant to mating surface of water pump as shown in
figure.
"A" : Sealant 99000-31150
Sealant quantity (to mating surface of water pump)
"a"
Width "a" : 3mm (0.12 in.)
"b"
Height "b" : 2mm (0.08 in.)
2) Install water pump assembly (1) to cylinder block and tighten
bolts and nut to specified torque.
Tightening torque
Water pump bolts and nut (a) : 22 N·m (2.2 kg-m, 16.0 lb-ft)
3) Install water pump pulley.
4) Install water pump/generator drive belt. Refer to "WATER
PUMP/GENERATOR DRIVE BELT" in this Section.
5) Install A/C compressor belt (if equipped). Refer to "COM-
PRESSOR DRIVE BELT" in Section 1B.
6) Fill coolant. Refer to "COOLING SYSTEM REFILL".
7) Connect negative cable at battery.
8) Check each part for leakage.
ENGINE COOLING 6B-17
Advertisement
Table of Contents
