Table of Contents
Advertisement
09931-76011
SUZUKI scan tool kit
(See NOTE.)
NOTE:
This kit includes the following items.
1. Storage case, 2. Operator's manual, 3. Tech 1A, 4. DLC cable (14/26 pin, 09931-76040),
5. Test lead/probe, 6. Power source cable, 7. DLC cable adaptor, 8. Self-test adaptor
7) If ignition timing is out of specification, check the followings:
• CKP sensor
• CKP sensor plate
• TP sensor
• Test switch signal circuit
• VSS
• Timing chain cover installation
8) After checking Initial Ignition Timing, release ignition timing
fixation by using SUZUKI scan tool or disconnect service
wire from monitor connector.
9) With engine idling (test switch terminal ungrounded, throttle
opening at closed position and car stopped), check that igni-
tion timing is about 7°–17° BTDC. (Constant variation within
a few degrees from 7°–17° indicates no abnormality but
proves operation of electronic timing control system.) Also,
check that increasing engine speed advances ignition timing.
If above check results are not satisfactory, check CKP sen-
sor, test switch terminal circuit and ECM.
SPECIAL TOOL
Mass storage cartridge
IGNITION SYSTEM (ELECTRONIC IGNITION SYSTEM 6F1-9
09931-76030
16/14 pin DLC cable
Advertisement
Table of Contents
