Drive Shaft Joint Cage Installing Pipe Diameter - Suzuki Liana RH418 Supplementary Service Manual

3A-9 Drive Shaft / Axle:
[A]: Wheel side
[B]: Differential side
1) Install new wheel side boot big band and small band
in the same manner as Step 1) to 8) of tripod joint
type.
2) Install damper (1) on left drive shaft according to
dimension specified as follows.
Drive shaft damper installing position (distance
"a" between reference position and damper)
Left side drive shaft: 187.0 – 193.0 mm (7.37 –
7.59 in.)
Right side drive shaft: 154.3 – 160.3 mm (6.08 –
6.31 in.)
3) Set new differential side small band and new
differential side boot on shaft temporarily.
4) Drive in the cage (1) using a pipe (2).
CAUTION
!
Install cage directing smaller outside
diameter side to wheel side.

Drive shaft joint cage installing pipe diameter

"a": 23.0 mm (0.906 in.) or more
"b": 32.0 mm (1.260 in.) or less
5) Install circlip (1) using special tool.
Special tool
I3RH0A311012-01
(A): 09900-06107
I4RH01311009-01
I2RH01310034-01
I2RH01310035-01