Table of Contents
Advertisement
4A-12 FRONT DRIVE SHAFT
7) Driver in the cage (1) by using a pipe (2).
Drive shaft joint cage installing pipe diameter
"a" : 22.5 mm (0.886 in.) or more
"b" : 30.0 mm (1.181 in.) or less
CAUTION:
Install cage directing smaller outside diameter side to
wheel side.
8) Install circlip (1) by using special tool (A).
Special tool
(A) : 09900-06107
9) Apply grease to entire surface of cage.
Use specified grease in tube included in spare parts.
10) Insert cage into outer race and fit snap ring (1) into groove of
outer race (2).
CAUTION:
Position opening of snap ring "c" so that it will not be
lined up with a ball.
11) Apply grease to inside of outer race, and fit boot to outer
race. After fitting boot, insert screwdriver into boot on outer
race side and allow air to enter boot so that air pressure in
boot becomes the same as atmospheric pressure.
Advertisement
Table of Contents
