44) Apply grease to thrust needle roller bearing (1) and install it.
"A" : Grease 99000-25030
45) Apply grease to clutch drum thrust washer (1) and install it to
oil pump assembly (2).
"A" : Grease 99000-25030
46) Install new gasket to transmission case and install oil pump
assembly (1) to transmission case.
Tightening torque
Oil pump assembly bolts (a) : 12 N·m (1.2 kg-m, 9.0 lb-ft)
47) Measure input shaft end (2) play.
Set dial gauge (1) as shown in figure and measure the play
of the input shaft.
Input shaft end Play
Standard : 0.3 – 0.7 mm (0.012 – 0.028 in.)
48) If the obtained value is out of standard value, select thrust
bearing race (installed in step 41)) of different thickness
shown in table below and adjust the play.
Available thrust bearing race size (thickness)
1.3 mm (0.051 in.), 1.7 mm (0.067 in.) or 2.1 mm (0.083 in.)
3. Oil pump
AUTOMATIC TRANSMISSION (4 A/T) 7B-129