Suzuki Ignis Service Manual page 839

7B-94 AUTOMATIC TRANSMISSION (4 A/T)
6) Install snap ring (1).
NOTE:
Make sure that the ends of the snap ring do not come to
the opening of the front clutch No.1 drum.
7) Place special tool (A) on soft jawed vise (1) and install 2 oil
seal rings on special tool.
Special tool
(A) : 09926-26030
(B) : Clutch drum seal ring 22831-83E10 SUZUKI GENUINE
PARTS
NOTE:
• Clutch drum seal set has two seal rings in a set.
• Do not use the seal rings removed from oil pump
assembly. It is not necessary to remove seal rings
from special tool once installed.
8) Place front clutch assembly (1) on special tool (A).
9) Set dial gauge (4) on the top of clutch flange (2) and mea-
sure clearance by blowing compressed air (4 kg/cm
as shown in figure.
If the clearance is out of specification, replace clutch discs,
plates and flange.
Front clutch disc clearance
: 0.47 – 1.14 mm (0.0185 – 0.0448 in.)
3. Air gun
2
, 57 psi)