Suzuki Ignis Service Manual page 451

DTC CONFIRMATION PROCEDURE
WARNING:
• When performing a road test, select a place where there is no traffic or possibility of a traffic acci-
dent and be very careful during testing to avoid occurrence of an accident.
• Road test should be carried out with 2 persons, a driver and a tester, on a level road.
1) Turn ignition switch OFF.
2) Clear DTC with ignition switch ON.
3) Check vehicle and environmental condition for :
– Altitude (barometric pressure) : 2400 m, 8000 ft or less (560 mmHg, 75 kPa or more)
– Ambient temp. : –10°C, 14°F or higher
– Intake air temp. : 70°C, 158°F or lower
4) Start engine and drive vehicle under usual driving condition (described in DTC confirmation procedure of
DTC P0136) for 5 min. or longer and until engine is warmed up to normal operating temperature.
5) Keep vehicle speed at 30 – 40 mph, 50 – 60 km/h in 5th gear or "D" range for 5 min. or more.
6) Stop vehicle (do not turn ignition switch OFF).
7) Check pending DTC in "ON BOARD TEST" or "PENDING DTC" mode and DTC in "DTC" mode.
INSPECTION
Step
1 Was "ENGINE DIAG. FLOW TABLE" per-
formed?
2 Is there DTC(s) other than fuel system (DTC
P0171/P0172)?
3 Check HO2S-1 Output Voltage.
1) Connect scan tool to DLC with ignition
switch OFF.
2) Warm up engine to normal operating tem-
perature and keep it at 2000 r/min. for 60
sec.
3) Repeat racing engine (Repeat depressing
accelerator pedal 5 to 6 times continuously
and take foot off from pedal to enrich and
enlean A/F mixture). See Fig. 1.
Does HO2S-1 output voltage deflect between
below 0.3 V and over 0.6 V repeatedly?
4 Check Fuel Pressure (Refer to section 6E1 for
details).
1) Release fuel pressure from fuel feed line.
2) Install fuel pressure gauge.
3) Check fuel pressure. See Fig. 2. With fuel
pump operating and engine at stop :
270 – 310 kPa, 2.7 – 3.1 kg/cm
44.0 psi.
At specified idle speed :
270 – 310 kPa, 2.7 – 3.1 kg/cm
44.0 psi.
Is measured value as specified?
Action
2
, 38.4 –
2
, 38.4 –
ENGINE GENERAL INFORMATION AND DIAGNOSIS 6-77
Yes
Go to Step 2.
Go to applicable DTC
Diag. Flow Table.
Go to Step 4.
Go to Step 5.
No
Go to "ENGINE DIAG.
FLOW TABLE".
Go to Step 3.
Go to DTC P0130 Diag.
Flow Table (HO2S-1 cir-
cuit check).
Go to Diag. Flow Table B-
3 Fuel Pressure Check.