Table of Contents
Advertisement
1A-6 HEATER AND VENTILATION
REMOVAL
1) Disconnect negative (–) cable at battery.
2) Drain engine coolant and disconnect heater hoses (1) from
heater unit.
3) Remove heater unit mounting nut (2).
4) Remove instrument panel by referring to "INSTRUMENT
PANEL" in Section 9.
5) Disconnect blower motor and resistor couplers from heater
unit.
6) Remove bolts (1), nuts (2) and screws (3) as shown.
7) Remove cooling unit (4) and heater unit (5) from vehicle.
INSTALLATION
Reverse removal procedure to install heater unit noting the follow-
ing instructions.
• When installing each part, be careful not to catch any cable
or wiring harness.
• Adjust heater control cable by referring to "HEATER CON-
TROL LEVER ASSEMBLY" in this section.
• Fill engine coolant to radiator.
Advertisement
Table of Contents
