Table of Contents
Advertisement
8) Connect brake pipe to wheel cylinder and tighten brake pipe
flare nut to specified torque.
Tightening torque
Brake pipe flare nut (b) : 16 N·m (1.6 kg-m, 11.5 lb-ft)
9) Refill rear axle (differential) housing with new specified gear
oil. Refer to Section 7F for refill.
10) Install brake drum. For details, refer to "BRAKE DRUM" of
Section 5.
11) Connect parking brake cable (1) to parking brake shoe lever.
Secure parking brake cable to brake back plate with clip (2).
Install wheel speed sensor (if equipped with ABS).
CAUTION:
Check to ensure that clip is in good condition before
installing it. If deformed or broken, replace.
12) Fill reservoir with brake fluid and bleed brake system. (For
bleeding operation, refer to "BLEEDING BRAKES" in Sec-
tion 5.)
13) Install wheel and tighten wheel nuts to specified torque.
14) Upon completion of all jobs, pull parking brake lever with
about 20 kg, (44 lbs) load three to five times so as to obtain
proper drum-to-shoe clearance.
Adjust parking brake cable (for adjustment, refer to "PARK-
ING BRAKE INSPECTION AND ADJUSTMENT" in Section
5).
15) Check to ensure that brake drum is free from dragging and
proper braking is obtained.
16) Perform brake test (foot brake and parking brake).
(For brake test, see Section 5.)
17) Check each installed part for oil leakage.
1. Plug cap
2. Vinyl tube (See-through tube)
3. Container
REAR AXLE SHAFT OIL SEAL (4WD VEHI-
CLE)
REMOVAL
1) Remove rear axle shaft. For details, refer to steps 1) to 8) of
"REAR AXLE SHAFT AND WHEEL BEARING" in this sec-
tion.
REAR SUSPENSION 3E-25
Advertisement
Table of Contents
