Table of Contents
Advertisement
5-36 BRAKES
2) Attach secondary cup (1) to secondary piston (2), they install
it to cylinder body such a direction as shown.
NOTE:
• Secondary cup is the same as primary cup.
• Diameter of secondary cup is the largest compared
with sleeve cup and cap cup.
3) Push secondary cup to the bottom by using special tool.
Special tool
(A) : 09951-18220
(A)
4) Remove O-ring (1) from sleeve (2).
Special tool
(A) : 09900-06106
CAUTION:
Do not cause any damage to inside of sleeve.
If caused, replace primary piston assembly.
5) Install sleeve cup (3) and O-ring (2) to sleeve (1) such a
direction as shown.
NOTE:
• Diameter of sleeve cup and O-ring are smaller than
those of cap.
• O-ring is the same as that of smaller one of cap O-ring.
6) Install sleeve assembly with aligning protrusion (1) of sleeve
and dent (2) of cylinder body.
Advertisement
Table of Contents
