Rear Axle Housing (4Wd Vehicle) - Suzuki Ignis Service Manual

3E-26 REAR SUSPENSION
2) Remove rear axle shaft oil seal (1) by using special tool.
Special tool
(A) : 09913-50121
2. Axle housing
INSTALLATION
1) Using special tools, drive in oil seal (1) or (2) until it contacts
oil seal protector (3) in axle housing.
NOTE:
• There are 2 types of oil seal ((1) & (2)). Their shapes are dif-
ferent as shown in the figure but they are both usable.
• Special Tool (B) can be used for both oil seals (1) and (2).
• Make sure that oil seal is free from inclination as it is
installed.
• Refer to the figure to check that oil seal is installed in
proper direction.
CAUTION:
When installing oil seal (2), never hit any part other than
the position indicated as (6) in the figure. Make sure to
use special tools indicated below. Failure to observe this
caution will cause oil seal to be deformed and oil leakage
to occur.
Special tools
(A) : 09924-74510
(B) : 09944-67010
"A" : Grease 99000-25010
4. Differential side
5. Apply grease here
6. Press-fitting point
2) For procedure hereafter, refer to steps 5) to 7) of "REAR
AXLE SHAFT AND WHEEL BEARING" in this section.

REAR AXLE HOUSING (4WD VEHICLE)

REMOVAL
1) Hoist vehicle.
2) Remove rear axle shaft referring to item 2) to 8) of "REAR
AXLE SHAFT AND WHEEL BEARING" in this section.
3) Disconnect brake pipe from flexible hose and remove E-ring.
4) Remove brake pipe clamps and pipes from axle housing.
5) Remove parking brake cable clamps and disconnect parking
brake cable from axle housing.
6) Remove wheel speed sensor and release clamps from axle
housing (if equipped with ABS).
7) Remove LSPV adjust nut and detach spring end from rear
axle housing (if equipped with LSPV).