Table of Contents
Advertisement
6) Unbend bent part of tie rod lock washer (1) and remove tie
rod (2) from rack (3).
INSTALLATION
1) Install new tie rod lock washer (2) and tie rod (3) to rack (1).
Align straight part "A" of washer with flat part "B" of rack.
NOTE:
For correct installation of tie rod lock washer, referring to
the figure.
"B": Upper
2) Tighten tie rod inside ball nut to specified torque.
Tightening torque
Tie rod inside ball nut (a) : 85 N·m (8.5 kg-m, 61.5 lb-ft)
3) Bend new lock washer to tie rod side as shown.
MANUAL RACK AND PINION 3B-11
Advertisement
Table of Contents
