Chapter 1 Setting Up The Ace; Prerequisites For Setting Up The Ace; Default Settings - Cisco 4700M Administration Manual

Prerequisites for Setting Up the ACE

Prerequisites for Setting Up the ACE
Setting up the ACE has the following requirements:
•
•

Default Settings

Table 1-1
Table 1-1
Parameter
User accounts
Host name
Cisco 4700 Series Application Control Engine Appliance Administration Guide
1-2
Terminal—The terminal that you use to communicate with the ACE must contain a terminal
communications application, such as HyperTerminal for Windows, and be configured as follows:
Asynchronous transmission
–
9600 baud
–
8 data bits
–
Hardware flow control
–
1 stop bit
–
No parity
–
Cable—The cable that connects the terminal to the ACE must meet the following requirements:
Serial cable with an RJ-45 connector
–
Adapter—RJ45 to DB-9 male
–
Cable type—Rollover serial cable to connect the ACE to a DTE device
–
For instructions on connecting a console cable to your ACE, see the Cisco Application Control
Engine Appliance Hardware Installation Guide.
lists the default settings for the ACE setup parameters.
Default Setup Parameters
Default
Administrator account:
username: admin / password: admin
XML interface account:
username: www: / password: admin
Device Manager GUI access account:
username: dm / password: N/A
switch
Chapter 1 Setting Up the ACE
OL-20823-01