Status Output (Signal Output); Parameterizing By Keyboard - Honeywell EK280 Applications Manual

EK280

6.3 Status output (signal output)

Each of the outputs 1 to 4 (terminals DA1 to DA4) can be programmed as a status output (signal output).

6.3.1 Parameterizing by keyboard

i
The use of enSuite parameterizing software is strongly recommended for parameterizing a status
output (see below).
Parameterization with the keyboard on the EK280 is described below.
a) Setting up the output mode:
− Move the cursor to the tab "Serv." and subsequently via the following path to the mode for the
corresponding output "Md.O1" to "Md.O4":
Serv.  Outputs
Serv. Outputs

Serv.  Outputs
Serv.  Outputs
i
The status outputs of the EK280 can be operated with active or inactive logic. The output mode
must be programmed accordingly for this purpose (see below).
− Press the ENTER key. ⇒ The actual parameterized value flashes.
− Press one of the arrow keys  or  until the
"status+" (Logic active: message is active, when the output is switched on.) or
inactive: message is active, when the output is switched off) flashes.
− Press the ENTER key to confirm the value setting. Input can be canceled using the ESC key.
b) Setting up the status display for the output:
− When in the corresponding menu press the  key repeatedly until "SpO1", "SpO2", "SpO3", or
"SpO4" is displayed.
− Press the ENTER key. ⇒ The actual parameterized value flashes.
− Move the cursor to the digits using the  or  arrow keys and update them using the  or  arrow
keys to a value specified in the table.
Application Manual
 Output 1  Md.O1
Output 2 Md.O2
 
 Output 3  Md.O3
 Output 4  Md.O4
45
"status-" (Logic