Fe260 Gsm/Gprs/Umts Version Ftp Operating Mode - Honeywell EK280 Applications Manual

EK280

7.4.7 FE260 GSM/GPRS/UMTS version FTP operating mode

7.4.7.1 FTP operation, depending on the version of EK280
From the EK280-version 2.50, the FTP data transfer is controlled by the EK280 itself. This differs from
previous versions, where for handling the "FTP Pushes", the modem application "ComFTP" is needed.
i
From V2.50 and higher, no special "ComFTP" modem is required for the FTP data transmission
with EK280. Rather, it can be used with the GPRS and UMTS modems, which are usable
according to the table in  chapter
As of version V2.50 of the EK280 firmware, the ComFTP modems are no longer supported!
The FTP data transmission via GPRS and/or UMTS with an EK280 as of V2.50 is described in the  chapter
7.4.7.2.
i
The modem application "ComFTP" is required for FTP data transmission with an EK280 up to
and including V2.40. "ComFTP" is software in a modem that reads data cyclically from the
EK280, processes it and transfers it via "FTP Push" to a pre-specified FTP server.
The operation of an EK280 up to and including V2.40 with a ComFTP modem is described in  chapter
7.4.7.3.
7.4.7.2 FTP data transfer via GPRS and/or UMTS without ComFTP (EK280 from V2.50)
For commissioning the FTP data transfer via the FE260, the EK280 must first be configured for GPRS and/or
UMTS operation. Here, a distinction must be made between whether the FTP data transmission is to take
place within a VPN or via the Internet:
29
− If the FTP data transfer is to be carried out within a VPN, the parameterization is the same as for
TCPserv operation ( chapter 7.1.5). In so doing, among other things, the access data to the VPN is
entered in the menu
these are:
Parameter
GPRS Access Point Name "APN"
2:781 – APN User Name
2:782 – APN password
and optionally (only if the FTP server is not defined by an IP address, but by a URL address):
2:794 – Domain Name Server 1
2:795 – Domain Name Server 2
− If the FTP data transfer is to be done over the Internet, the provider-dependent access data to the
public Internet are entered in the menu
GPRS" instead of the access data to a VPN.
VPN = Virtual Private Network
29
Application Manual
7.4.2 for FTP data transmission.
"Parameter – Interfaces – Terminal interface – GSM and
"Parameter – Interfaces – Terminal interface – GSM and
Request access data from your own
130
GPRS". In detail,
provider.