Honeywell EK280 Applications Manual page 167

EK280
Display Description
15 Data transfer via SMS is in progress.
16 Data transfer via SMS is complete.
29 No valid recipient specified.
30 A communication error occurred.
This message is shown for example, if a modem to be used has no power supply.
31 The modem's supply voltage is too low.
32 The modem cannot be used due to SIM card error (modem message: "SIM Error")
33 The modem cannot be used as an incorrect PIN has been entered.
34 The modem cannot be used as an incorrect PUK has been entered.
35 Communication link to the network cannot be established or the communication link to the
network was lost, before the communication link to the remote site could be established.
36 Communication link to the GSM network was denied.
37 The APN parameters required to establish a GPRS communication link are missing.
38 Communication link to APN
39 The port for server connection is not defined.
40 The target name or port is not defined.
41 The other party has disconnected.
42 The communication link to the network was lost, after a communication link to the remote party
was already established.
43 The phone number of the SMS service center is wrong or missing at the SIM card.
The mobile service provider must be contacted.
44 The APN password or APN user name is wrong.
45 The APN parameters are already in use by another mobile phone subscriber.
70 Failed to establish communication link to the remote terminal
Possible cause: i.e. blocked by remote terminal firewall.
71 The remote terminal did not respond (timeout)
Possible causes: The remote terminal machine is switched off or the remote terminal has not
been started.
72 The remote terminal reports "unknown device type".
73 The EK280 does not understand the remote terminal response.
Possible causes: E.g. transfer error.
40 SMS only available from Software Version 2.20 or later
APN = "Access Point Name"
41
Application Manual
40
40
was denied.
41
40
165
41