Fe260 Gsm/Gprs/Umts Version, Gsm Operating Mode - Honeywell EK280 Applications Manual

EK280
− Move the cursor through the next digits using the  key and enter them.
− After entering the last digit press the
− Under "P.Sta" the
If "P.Sta" is not displayed, move the cursor down using the  arrow keys.
− As soon as a communications time window is opened via the modem, the new PIN is used. After a
few seconds, under "P.Sta" the message
message "Pin Error" if the PIN was incorrectly entered.

7.4.5 FE260 GSM/GPRS/UMTS version, GSM operating mode

Prerequisites for process described below:
− The FE260 is connected and configured as described in  chapter 7.4.1.
− The modem installed in the FE260 is suitable for GSM operation and is supported by the software
version installed in the connected EK280 (see table in  chapter 7.4.2).
− The SIM card is inserted as described in  chapter 7.4.3.
− The SIM card may be unlocked by entering the correct PIN as described in chapter 7.4.4.
7.4.5.1 EK280 Parameterization
i
For parameterization of the EK280 you need a connection cable for the optical interface as well
as the enSuite program. enSuite can be downloaded free of charge from the Honeywell website
in the "Software Downloads" section:
www.elster-instromet.com/en/software-downloads
a) Closing the time windows
In order that the parameterization works correctly the time windows 5 and 6 must be closed. To do this:
− Connect a PC or laptop with enSuite installed to the EK280 optical interface using the connection
cable.
− Start enSuite and set up the communication link to the EK280.
( chapter 3.1 Setting up the communication link to the EK280 via optical
− Select "Navigation" on the left-hand side and then
navigation window.
− In the top of the device window open the path "Parameters" > "Interfaces" by clicking on the relevant
plus signs, and then select
− In call windows 5 and 6 set start and end to the same value for each one and then select the
"Transfer changes to device" icon at the top of the enSuite window.
− Then wait a minute, for any communications activity in progress on the EK280 to be safely stopped.
b) Sending parameter file
− Depending on the GSM modem fitted to the FE260 (ECM-GW120 or Wavecom Integra M2106) send
one of the following parameter files to the EK280 ( chapter
Application Manual
ENTER
"Pin New" is now ready for confirmation.
"Pin
"Call time windows".
key, to save the input.
OK" is displayed if the correct PIN was entered, or the
"Parameterize online" at the bottom of the
3.6 Send parameter
118
interface, p. 19)
file, p. 21):