EK280
6.4 Time-synchronous output
Each of the outputs 1 to 4 (terminals DA1 to DA4) can be programmed as a time-synchronized output.
6.4.1 Parameterization
Parameterization is carried out via the keyboard on the EK280.
Alternatively, parametrization can be carried out using the enSuite program. The paths which are
subsequently described can be found in enSuite under
a)
Setting up the output mode:
−
Move the cursor to the tab "Serv." and subsequently via the following path to the mode for the
corresponding output "Md.O1" to "Md.O4":
Serv.
Outputs
Serv.
Outputs
Serv.
Outputs
Serv.
Outputs
i
The time-synchronized outputs of the EK280 can be operated with active or inactive logic. The
output mode must be programmed accordingly for this purpose (see below).
−
Press the ENTER key. ⇒ The actual parameterized value flashes.
−
Press one of the arrow keys or until the text
inactive) flashes.
−
Press the ENTER key to confirm the set value. It is possible to abort the entry by pressing the ESC
key.
b)
Setting up the source for the output:
i
Parametrization of the source for the output via the EK280 keyboard is only possible with
software version 2.20 or later.
Older software versions may be programmed using enSuite via
"Parameters" and the paths described ( chapter 6.4.1)
−
When in the corresponding menu press the key until "Sc.O1", "Sc.O2", "Sc.O3", or "Sc.O4" is
displayed.
−
Press the ENTER key. ⇒ The actual parameterized value flashes.
Move the cursor to the digits using the or arrow keys and update them using the or arrow
−
keys to a value specified in the table.
Application Manual
Output 1
Md.O1
Output 2
Md.O2
Output 3
Md.O3
Output 4
Md.O4
"Parameterize
online" > "Parameters".
"time sync+"
(Logic active) or
"Parameterize
48
"time sync-"
(Logic
online" >