Table of Contents
Advertisement
Data transfer
i
If the supply type "Always" is used, the EK205-M is active during the set time window
regardless of the voltage supply! In battery mode (in the same way as for supply type
"Battery"), this can result in a significant reduction in the battery service life to just a few
months!
The forecast remaining battery service life "Bat.R" does not take account of this case.
8.3.2 Connection configuration status StCon
Display Meaning
0
Establishment of a connection has not yet started.
2
The interface is being activated for the connection.
3
The interface to be used for the connection (e.g. the modem) is busy, the EK205-M will wait until
the connection can be established.
Either the interface is still being used for another connection or the EK205-M is waiting to
try again after a failed connection attempt.
This state may persist for several minutes.
The interface (e.g. the modem) is ready to establish a connection (e.g. the call time window is
4
open).
5
The interface is being released for the connection.
6
The interface (e.g. the modem) is released for use by other connections (e.g. when the time
window is no longer open).
7
Data transfer via DLMS protocol is in progress.
8
Data transfer via DLMS protocol is complete.
9
Data transfer via Modbus protocol is in progress.
10
Data transfer via Modbus protocol is complete.
11
Data transfer via LIS-200 protocol is in progress.
12
Data transfer via LIS-200 protocol is complete.
15
SMS transfer is in progress.
16
SMS transfer is complete.
29
No valid recipient specified.
30
A communication error occurred.
This message is shown, for example, if a modem to be used has no power supply.
The modem's supply voltage is too low.
31
32
The modem cannot be used due to a SIM card error (modem message: SIM Error).
33
The modem cannot be used as an incorrect PIN has been entered.
34
The modem cannot be used as an incorrect PUK has been entered.
35
The communication link to the network cannot be established or the communication link to the
network was lost before the communication link to the remote subscriber could be established.
36
The communication link to the GSM network was denied.
37
The APN parameters required to establish a GPRS communication link are missing.
38
The communication link to the APN was denied.
39
The port for server connection was not configured.
40
The destination name or port was not configured.
41
The remote subscriber has disconnected.
The communication link to the network was lost after a communication link to the remote
42
subscriber had already been established.
43
The telephone number of the SMS service center is wrong or missing on the SIM card.
The mobile service provider must be contacted.
81
Advertisement
Table of Contents
