Time Window Connection; Point-In-Time Connection - Honeywell EK280 Applications Manual

EK280
The paths which are subsequently described can be found in the enSuite program under
"Parameterize online" > "Parameters" > "Interfaces".
All connections are inactive as per factory settings and are preset as follows:
Connection Event type
1 Time window
2 Time window
3 Time window
4 Time window
5 Time window
6 Time window
7 Time
8 Time

7.6.1 Time window connection

The major parameters for activating a time window connection are listed below.
For parameterizing, use the enSuite program and change over to the sub-menu
"Connection 1 to 6".
Time
window
connection
cycle Cycle of a regular time window connection (e.g. hourly, daily, weekly, monthly)
start Start of a time window connection (e.g. daily at 00:00, or another time)
end End of a time window connection (e.g. daily at 11:59 PM, or another time)
StCon Current status of this connection
If the conditions for activating the time window connection are satisfied, then the interface is opened and the
EK280 is ready to act as a recipient. If a modem is connected to this interface then the EK280 is only ready
to act as a recipient after a further 30 seconds.
The conditions for activating a time window connection are:
− Is the current device time within the time window which has been parameterized?
− Does the supply to the EK280 correspond with the parametrization of the connection?

7.6.2 Point-in-time connection

The major parameters for activating a point in time connection are listed below.
To do so, in the enSuite program, change the sub menu
Application Manual
Interface
internal modem
internal modem
internal modem
internal modem
Terminal / ext. modem
Terminal / ext. modem
internal modem
internal modem
Meaning
"Connections"
Power supply
Battery
Battery
ext. power supply
ext. power supply
ext. power supply
ext. power supply
always
always
"Connections"
> "Connection 7 or
162
>
8".