Honeywell EK280 Applications Manual page 96

EK280
7.2.2.10 Connecting the cable to the Ethernet module
Attention!
Always switch off the PoE power supply before connecting the network cable and
secure it against being switched on again!
The safest way is to remove the network cable from the switch or the network socket.
− Now guide the cable ends into the connector of the Ethernet module.
The core assignment is printed in front of the connector. The cores with the ferrules only need to be
inserted. For this, it is NOT necessary to activate the white actuator on the terminal block. This is
only required if the cable has to be removed again.
i
If you cannot insert the cable with your fingers, a small screwdriver can be used to press onto the
collar of the ferrule ( Fig. below).
This is what the connected cable looks like:
The cable length was dimensioned such that the twisted core pairs bend slightly when the cover is open,
without being tensioned.
Application Manual 94