Setting Up The Communication Link To Ek280 Via A Network (Tcp/Ip); Setting Up A Direct Communication Link To Ek280; Updating Customized Parameters - Honeywell EK280 Applications Manual

EK280

3.3 Setting up the communication link to EK280 via a network (TCP/IP)

Prerequisite:
A communication link between enSuite and the EK280 ( chapter
− Ensure your PC or laptop is connected to the LAN. The EK280 must be connected to the same
network.
− Start the enSuite program (i.e.
− Press symbol "Search
− In the "Search device and
− Select "Access"
settings".
− In the field "Key" enter the administrator key.
− Enter the EK280's IP address under "Address" and port number under "Port".
− Press "OK".
After a few seconds "connected" is displayed at the bottom of the "Output" window.
−

3.4 Setting up a direct communication link to EK280

Prerequisite:
A communication link between enSuite and the EK280 ( chapter
− Ensure your PC or laptop has a COM port.
− Start the enSuite program (i.e.
− Select the "Search
− In the "Search device and
− Select "Access"
default settings".
− Enter the serial communication link speed under
− Press "OK".
− After a few seconds "connected" is displayed at the bottom of the "Output" window.

3.5 Updating customized parameters

Prerequisite:
A communication link between enSuite and the EK280 via optical interface, modem or network
(TCP/IP) has been set up ( chapters
− Select "Navigation" on the left-hand side.
− Click on the plus sign beside
your devices.
− Click on the entry beginning with the serial number of the connected device.
Application Manual
Start > Programs > Elster >
device..." (magnifying glass symbol).
connect" window select the "LIS200" tab.
 "Administrator", "Connection"  "TCP/IP" and
"LIS200", "User"

Start > Programs > Elster >
device..." icon (magnifying glass icon).
connect" window select the "LIS200" tab
"LIS200", "User"  "Administrator", "Connection" 

3.1
"My Devices" in the newly-opened navigation window, to see a list of
7 Data
enSuite).
7 Data
enSuite).
"Baud rate".
to 3.3).
transfer, p. 58).
"use default
transfer, p. 58).
"Serial RS232" and "use
20