Unlocking The Sim Card In The Fe260 (Entering The Pin) - Honeywell EK280 Applications Manual

EK280
− Close flap again and lock (slide metal strap under slight pressure to the left).
The chamfered edge of the SIM must now be located at bottom left as shown.
− Screw the FE260 housing back on.
7.4.3.2 Inserting the SIM card into the modem "Integra-M2106+" and "Integra-M2106B"
Mortal danger!
Ensure the mains voltage is disconnected before opening the FE260 housing, ensure it
is not turned back on and verify that there is no voltage.
− Remove the four screws from the top of the FE260 and open it.
− Ensure that the "JP2" (mode) jumper is in the "operation" position.
− Press the eject button with for example a ballpoint pen or similar, to remove the SIM card slider.
− Insert the SIM card into the card slot (i.e., the SIM carriage) so that the gold-plated contact face
upwards. The chamfered corner of the SIM card is at the bottom left (as illustrated on the print)
SIM card slot
Press the button to open
the SIM card slider.
− Push the SIM card and slider back into the modem until the slider clicks into place.
− Screw the FE260 housing back on.

7.4.4 Unlocking the SIM card in the FE260 (entering the PIN)

If the inserted SIM card's PIN ("Personal Identification Number") is activated, carry out the following
instructions to unlock it:
− Move the cursor to the "Serv." tab in the EK280's display, then to
Interfaces > Terminal interface > GSM & GPRS > PIN
− Press the
ENTER
i
The PIN must be entered right-aligned in the EK280!
Application Manual
Fig. 11: Integra modem with SIM card slot
key and enter the first PIN digit using the  and arrow keys.
Jumper "JP2" ("Mode") in the
uppermost position "operation"
Integra M2106+
GSM antenna connection
Chamfered corner of the SIM
117